What’s the Best Engine Oil For a Chevrolet Cruze?

Questions and Answers

Is engine oil and motor oil the same thing?

Engine oil and motor oil are synonymous terms. Both are essentially identical products. A base oil, viscosity improvers, antiwear additives, dispersants, and detergents make up engine/motor oil.

They lubricate engine parts and gears, clean combustion residues, cool engines, and improve piston rings and cylinder sealings.

What is the Chevrolet Cruze’s oil capacity?

The oil capacity is the amount of engine oil required for a car to run smoothly. The oil capacity of the first-generation Chevrolet Cruze ranges from 4.25 quarts to 4.76 quarts, while that of the second generation ranges from 4.2 quarts to 5.3 quarts.

How To Check the Engine Oil Level?

To prevent your car from running out of engine oil, check the level of your engine oil every 400 miles and before long trips.

Here is a list of engine oil checking instructions:

1. Turn off the vehicle and park it on level ground for at least two hours.
2. Check the engine oil level by removing the dipstick.
3. Pull out the dipstick, wipe it clean, and replace it.
4. While holding the pin-down, check the engine oil level again.
5. Check that the oil level is below the cross-hatched area at the stick’s tip.

How to Change the Engine Oil In Your Car?

If you enjoy working on your car, changing your own oil would be a rewarding experience. It will also undoubtedly save you money.

Here’s how to change your Chevrolet Cruze’s engine oil:

1. To open your car, jack it up. Before removing the engine cover or the undercarriage to access the oil pan and oil filter, make sure you have enough working space. You should also look for oil leaks. If you notice any, have a mechanic inspect your vehicle.
2. Drain the oil by locating the drain plug. Set up a container large enough to hold all of the oil that will be drained from your car. This will prevent your oil from leaking into the floor and causing a sloppy mess. Allow the oil to drain into the container after unplugging the drain plug.
3. Take out the old oil filter. It is a small cylindrical component that is screwed onto the engine. Loosen it with an oil filter wrench until it falls towards the receptacle. Also, make certain that the old oil-filter gasket, which is a thin rubber O-ring, is not left behind. Failure to remove this will prevent the new filter from properly sealing. This will result in oil leaks, which can be disastrous for your vehicle.
   Change the drain plug. Avoid overtightening the drain plug when replacing it. Simply keep it snug to avoid damaging the oil pan or drain plug. Then, coat a small amount of your new engine oil around the rubber gasket to properly seal the new oil filter. After that, replace the undertray and lower the car back to the ground.
4. Fill the engine with the amount of oil recommended by the manufacturer. Remove the oil cap from your car after opening the hood.
5. Then, using a funnel, fill the engine to the manufacturer’s recommended oil volume. Avoid overfilling as this can result in engine damage. If you slip and pour too much, simply drain it as if you were removing old oil, or have a professional remove the excess oil.
6. Examine the oil level. Allow the oil to settle for a few minutes after you’ve added the appropriate amount. The final step is to use your dipstick to check the oil level. After you’ve completed all of this, you can restart the engine. Allow the vehicle to warm up while you check for leaks underneath it. Finally, after each successful oil change, remember to reset the engine oil system.

How Should You Dispose of Used Engine Oil?

Used engine oils should not be discarded or mixed with regular garbage. They are hazardous to the environment and even to humans. Always use sealable and leakproof containers when storing them. The best way to dispose of them is to take them to auto parts stores or service stations that recycle used motor oils and oil filters.

What Happens If I Use the Incorrect Engine Oil?

Using thinner, thicker, less viscous, or viscous oil than the one recommended for your vehicle will not result in immediate damage. In the long run, however, this may result in engine wear, increased oil consumption, and decreased fuel efficiency.

The worst that can happen to your car is extensive engine damage. However, if you use the incorrect engine oil, you can simply drain it yourself or visit an auto shop for an oil change.

Final Thoughts

The Chevrolet Cruze performs best with full synthetic Dexos oils in the viscosity grades of SAE 0W-20 and SAE 5W-30. GM has approved these oil recommendations to ensure high fuel efficiency, optimal engine performance, and long engine life. We’ve included specific engine oil brands that are best suited for your vehicle in this article.